Crest-electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL Uživatelský manuál stáhnout pdf (Strana 8)

1) Remove the locomotive shell. Refer to the manual included with your locomotive

to determine where the DCC/RCC socket is located. Turn the locomotive (or

tender) over, and remove all screws that hold the shell to the frame. Depending

on the model of the locomotive, the number of screws will vary.

2) Remove the jumper plug on the DCC/RCC socket and set it aside. You can

restore the locomotive to its pre-installation state by reinstalling the jumper plug.

3) Install the receiver in the 12 pin DCC/RCC socket and the 10 pin support socket

as shown making sure to match the 12 pin header to the 12 pin socket and the 10

pin header to the 10 pin socket.

Engine Main

Circuit Board

Jumper Plug

12 Pin DCC Socket

10 Pin Accessory

Socket

ENGINE MAIN

CIRCUIT BOARD

12 PIN DCC/RCC SOCKET

10 PIN SUPPORT

SOCKET

TE REVOLUTION

RECEIVER

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 39 40

Žádné komentáře

Crest-electronics CRE57000 TRAIN ENGINEER REVOLUTION MANUAL Uživatelský manuál Strana 8